Standard Floodlight Mount Installation

These instructions use Ring-supplied hardware. Your hardware may look different but the procedure should be similar.

Compatible with:

* Without the hardwire kit, this mount won't work with Ring Spotlight Cam+ Battery, Plug-In or Solar. We have a custom mount for designed for those models.

Included Hardware

Single 60 and Single 90

  • 2.5" crossbar kit
  • round gasket
  • 2x #8-3/4" screws

Dual 60

  • 5.5" crossbar kit
  • round gasket
  • 4x #8-3/4" screws
  • 8" wiring kit

Dual 90

  • 4" crossbar kit
  • round gasket
  • 4x #8-3/4" screws
  • 8" wiring kit

Step by Step

Preparing the crossbar.1. We usually preassemble the crossbar as shown. If yours came in as individual parts, assemble them as shown and tighten the nut below the crossbar. Installing the crossbar2. Install the crossbar over your junction box. Use the screws that came with your junction box to complete this step. Install mount on junction box3. Slide the mount over the threaded pipe and install the star washer and tighten the nut (Do not overtighten). Remove the 2 #8-3/4" Phillips-head screws and set them aside. You will need them for the next step.
4. Complete your wiring according to the floodlight manufacturer's instructions and install the crossbar as shown. Use the thread-forming screws for plastic we provided. Do not substitute. 5. Install the Ring Floodlight Camera baseplate using the center screw provided by Ring. From this point forward, follow the instructions provided by Ring as if you are doing a wall mount. S60 Mount with Ring Plus Installed6. Enjoy!