Three parts for Ubiquiti UniFi G6 cameras, all built around the G6 mounting interface.
Angled soffit wedges
Separate wedges for the G6 Turret and the G6 Bullet, each made to order in any whole-degree angle from 8° to 45° to counteract a sloped soffit and give the camera a level mounting surface. Base diameter is 127 mm (5 in); height varies with the angle. Each includes a gasket and crossbar hardware.
Dual mount
The Dual Mount for UniFi G-Series Cameras presents two G Turret interfaces in a 45-degree arrangement from a single junction box, so two cameras can watch two directions from one position. Published overall dimensions are 110 mm high by 160 mm wide. Includes crossbar hardware and a gasket, in two colors. This is a junction-box adapter rather than a soffit wedge, and it can be paired with a wedge if the mounting surface is sloped.
Before you order
These were designed for the G6 Turret and G6 Bullet. Earlier UniFi generations may use the same mounting hardware, but physical fit has not been confirmed — contact us before ordering for a pre-G6 camera. Angles must be submitted in whole degrees; a missing or fractional angle delays the order.
All three are Made to Order — No Returns. Each is produced in your selected configuration, so allow additional production time before shipment; because production is specific to your selection, returns are not accepted.
