120v Extension Wiring Kit

A 120v extension wiring kit is provided with some of our wired floodlight mounts and extensions. Oftentimes, the wire inside the junction box not enough to compete the installation.

PARTS

  • 3-position terminal block (Made in Germany)
  • 16AWG extension wires (Made in USA)

The 3-position terminal block allows you connect the 2 segments without having to cut and strip more of the house wire. When it is time to replace the fixture, all you need to do is loosen the screws and reuse the terminal.

ASSEMBLY

Single Mounts

  1. Remove approximately 10mm of the insulating material from the end of each of all 3 wires. Carefully fold the exposed wire in half. This technique enhances the security of the terminal block connection.
  2. Starting with the green/yellow ground wire, insert the stripped end into the terminal block and tighten the screw. Make sure the insulator doesn't go in the metal contacts.
  3. Repeat the same process for the other 2 colors. It doesn't matter which side the black or white wires go.

Dual Mounts

  1. Remove approximately 5mm of the insulating material from the end of each of all 6 wires.
  2. Starting with the 2 green/yellow ground wires, twist the stripped ends of the wires together and insert into the terminal block and tighten the screw. Make sure the insulator doesn't go in the metal contacts.
  3. Repeat the same process for the other 2 colors. It doesn't matter which side the black or white wires go.